B116, C15 Jalan Haji Ahmad, Perkampungan Seri Setali, 25300 Kuantan, Pahang, Malaysia.

+6019-323 7617

kstoolsdepot@gmail.com


Share:


LEO JET PUMPS - AJM 90



The LEO AJM 90 is a high-performance self-priming jet water pump designed for clean-water transfer, well-water lifting, garden irrigation and domestic or light commercial pressure boosting. It uses a 0.9 kW / 1.2 HP, 220 V single-phase motor, with a published flow range of approximately 5–65 L/min and a head range of 46–30 m. The pump uses 1" × 1" inlet and outlet connections.

LEO describes the AJm series as suitable for clean water or liquids with physical and chemical properties similar to water, including well-water lifting, garden sprinkler irrigation and running-water pressure boosting.

Technical Specifications

Specification LEO AJM 90
Brand LEO
Series AJm
Model AJM 90 / AJM90
Pump Type Self-Priming Jet Pump
Motor Power 0.9 kW / 1.2 HP
Voltage 220 V
Phase Single Phase
Frequency 50 Hz
Flow Range 5–65 L/min
Equivalent Flow Approx. 0.3–3.9 m³/h
Head Range 46–30 m
Maximum Head Approx. 46 m
Maximum Suction Approx. 9 m
Inlet 1"
Outlet 1"
Impeller Stainless Steel
Impeller Material AISI 304 Stainless Steel
Pump Body Cast Iron
Shaft/Support Components Stainless Steel
Motor Winding Copper
Insulation Class F
Protection Class IPX4
Maximum Liquid Temperature Up to 60°C in Malaysian listing
Maximum Ambient Temperature +40°C
Duty Continuous
Application Clean Water / Similar Liquids

The Malaysian AJM90 listing specifies 0.9 kW, 220 V, 5–65 L/min, 46–30 m head and 1" × 1" connections.

Pump Performance

The AJM90 is designed for applications requiring relatively high pressure from a compact surface-mounted pump.

Published performance:

  • Flow range: 5–65 L/min
  • Maximum flow: approximately 65 L/min
  • Maximum head: approximately 46 m
  • Operating head range: approximately 46–30 m
  • Maximum suction: approximately 9 m
  • Connection: 1" × 1"

The hydraulic curve means that the 46 m maximum head is achieved at very low or zero flow, while the pump produces its higher flow rates at lower head. Therefore, the 65 L/min maximum flow and 46 m maximum head should not be interpreted as occurring simultaneously.

Self-Priming Jet Pump Design

The AJM90 incorporates a self-priming jet-pump system, allowing it to draw water from a source below the pump. This makes it suitable for shallow wells, underground tanks and other installations where the water level is below the pump.

LEO specifically lists the AJm series for:

  • Well-water lifting
  • Garden sprinkler irrigation
  • Running-water pressure boosting
  • Domestic water supply
  • Supporting water-supply equipment

The maximum suction is listed at approximately 9 m by Malaysian product sources. Actual suction performance depends on elevation, atmospheric pressure, water temperature, suction-pipe diameter, pipe length, fittings and air-tightness.

For best results, the suction line should be properly sealed and appropriately sized, with unnecessary bends and restrictions avoided.

Stainless-Steel Impeller

The AJM90 uses a stainless-steel impeller, with Malaysian product information identifying the impeller material as AISI 304 stainless steel. This provides good corrosion resistance and durability for normal clean-water applications.

The stainless-steel impeller is advantageous for:

  • Domestic water supply
  • Well-water pumping
  • Irrigation
  • Water tank transfer
  • Pressure boosting

It is not intended to handle significant quantities of abrasive solids, sludge or fibrous wastewater.

Pump Body Construction

The standard AJM90 uses a cast-iron pump body, rather than being a completely stainless-steel pump.

This distinction is important when listing the product. The correct general description is:

Cast-iron pump body + stainless-steel impeller + stainless-steel shaft/support components.

LEO also offers stainless-steel-body variants in the AJm-S range, which should be listed separately from the standard AJM90.

Motor Specifications

The AJM90 is powered by a:

  • 0.9 kW / 1.2 HP motor
  • 220 V single-phase supply
  • 50 Hz
  • Copper winding
  • Class F insulation
  • IPX4 protection

The 0.9 kW motor provides a substantial increase in pressure capability compared with the smaller AJM75. The AJM90 reaches approximately 46 m maximum head, compared with approximately 38 m for the AJM75.

Motor Protection

The AJm series is designed with motor protection features appropriate for domestic and light commercial operation. Class F insulation provides enhanced thermal insulation capability, while IPX4 protection protects the motor against water splashing.

One detailed AJM90 specification also identifies the pump as suitable for outdoor installation where it is protected appropriately from direct environmental exposure.

Connection Size

The AJM90 uses:

Inlet: 1"
Outlet: 1"

The 1" connections provide a convenient arrangement for domestic water systems, garden irrigation and pressure-boosting installations.

For suction applications, the suction pipe should not be unnecessarily undersized. A properly sized suction line reduces pressure losses and helps maintain stable priming and pump performance.

Suitable Pumping Medium

The LEO AJm series is designed for clean water and liquids with physical and chemical properties similar to water.

The AJM90 should therefore not be selected as a dedicated sewage, sludge or solids-handling pump.

Avoid pumping liquids containing:

  • Large quantities of sand
  • Sludge
  • Fibrous solids
  • Abrasive particles
  • Aggressive chemicals

unless compatibility has been specifically confirmed.

Operating Temperature

Published Malaysian AJM90 information specifies a maximum liquid temperature of 60°C, while a separate AJM90 technical listing gives a maximum liquid temperature of +40°C. This indicates that temperature specifications can vary according to the particular regional/model configuration.

For a product catalogue, it is safest to state the specification applicable to the exact stock unit and nameplate. For ordinary domestic, well and irrigation water, this distinction normally has little practical effect.

Recommended Applications

The LEO AJM90 is suitable for a variety of clean-water applications.

1. Domestic Water Supply
Suitable for supplying clean water to residential properties where additional pressure is required.

2. Well-Water Pumping
The self-priming jet design makes it suitable for lifting water from shallow wells within the applicable suction limit.

3. Garden Irrigation
Suitable for garden sprinklers, hoses and small irrigation systems.

4. Pressure Boosting
The higher head capability makes the AJM90 particularly useful where stronger water pressure is required.

5. Water Tank Transfer
Suitable for transferring water between storage tanks and other water points.

6. Small Agricultural Applications
Can be used for clean-water transfer and irrigation duties.

7. Light Commercial Applications
Suitable for selected small commercial water-supply and pressure-boosting systems.

LEO specifically identifies well-water lifting, garden sprinkler irrigation and pressure boosting among the intended AJm applications.

Main Advantages

The LEO AJM90 provides:

  1. 0.9 kW / 1.2 HP motor for higher pressure applications.
  2. Self-priming jet-pump design.
  3. Up to approximately 65 L/min flow.
  4. Up to approximately 46 m head.
  5. Approximately 9 m maximum suction according to Malaysian listings.
  6. AISI 304 stainless-steel impeller.
  7. Copper motor winding.
  8. Class F insulation.
  9. IPX4 protection.
  10. 1" × 1" inlet/outlet.
  11. Compact surface-pump configuration.
  12. Suitable for domestic water supply, irrigation, wells and pressure boosting.

AJM Series Comparison

Model Motor Voltage Flow Range Head Range Max. Suction
AJM30 0.3 kW / 0.4 HP 220 V 5–35 L/min 30–14 m 9 m
AJM45 0.45 kW / 0.6 HP 220 V 5–35 L/min 36–18 m 9 m
AJM75 0.75 kW / 1.0 HP 220 V 5–65 L/min 38–23 m 9 m
AJM90 0.9 kW / 1.2 HP 220 V 5–65 L/min 46–30 m 9 m
AJM110 1.1 kW / 1.5 HP 220 V 10–100 L/min 52–27 m —

The AJM90 occupies an important position between the AJM75 and AJM110: it retains the approximately 65 L/min maximum flow of the AJM75 but provides substantially higher available head.

AJM90 vs AJM75

Feature AJM75 AJM90
Motor Power 0.75 kW / 1.0 HP 0.9 kW / 1.2 HP
Voltage 220 V 220 V
Maximum Flow 65 L/min 65 L/min
Maximum Head 38 m 46 m
Head Range 38–23 m 46–30 m
Max. Suction 9 m 9 m
Inlet/Outlet 1" × 1" 1" × 1"
Impeller Stainless Steel Stainless Steel

The key advantage of the AJM90 over the AJM75 is higher pressure/head capability, rather than a higher maximum flow rate.

Product Description

LEO AJM90 Jet Pump 0.9kW / 1.2HP 220V is a high-pressure self-priming jet water pump designed for clean-water transfer, well-water lifting, garden irrigation and domestic or light commercial pressure boosting. Powered by a 0.9 kW / 1.2 HP single-phase motor, the AJM90 delivers approximately 5–65 L/min flow with a 46–30 m head range, making it suitable for applications requiring stronger water pressure from a compact surface pump.

The AJM90 features an AISI 304 stainless-steel impeller, copper motor winding, Class F insulation and IPX4 protection. Its self-priming jet design allows water to be lifted from sources below the pump, while the 1" × 1" inlet and outlet provide convenient connection to domestic water-supply, irrigation and pressure-boosting systems.

With approximately 9 m maximum suction capability, the LEO AJM90 is a practical choice for well-water pumping, domestic water supply, garden irrigation, water tank transfer and pressure boosting where clean water is being pumped.

SEO Product Title

LEO AJM90 Jet Pump 0.9kW 1.2HP 220V Self-Priming Water Pump

Short Product Description

LEO AJM90 is a 0.9kW / 1.2HP 220V self-priming jet pump designed for clean-water transfer, well-water lifting, garden irrigation and pressure boosting. It delivers approximately 5–65 L/min flow with a 46–30 m head range, featuring an AISI 304 stainless-steel impeller, copper motor winding, Class F insulation, IPX4 protection and 1" × 1" inlet/outlet connections. With approximately 9 m maximum suction, it is suitable for domestic, agricultural and light commercial water-pumping applications.



 Inquiry - LEO JET PUMPS - AJM 90